Search results

Hi, i have a couple of questions regarding wiring. 1/ the black/white stripe wire from the csi (cold start injection) temperature sensor, is this a ignition fed positive or is this wire a ground? 2/ the wiring to the throttle position sensor 2 (i.e the one connected to the opposite end of...

thx i was confused as to why i had these blue red white etc wire in the harness going to the motor and i did not need them according to your wiring diagrams thanks john

Hi, need to know what this part is.. the first pic is a closeup of the part i am asking about.. the second pic shows overall view to show where it is... is this part of the traction control system if it is not part of the traction control do the wires need to be connected if they do...

It was the temp gauge switch i was after but now you mention what the others are... does the cold start injection switch need to be hooked up...i.e i think it is black/white stripe wire goes to the group of plugs that would normally be behind the glove box... and if so is it a power or earth...

hi where on the 1990 crown 1uzfe is the temp switch ( i know it is at the front left as you stand in front of the motor facing it) and is it just a single wire or is it 2 wires.. if it is 2 wires what colour is the plug Thanks john

Thanks for your quick reply... i think that was about the last wire that i had to work out before being able to start trimming wires that aren't needed John

Hi I have just bought a 1990 crown engine and just need to know if what i am thinking is right.. i am following the black/orange stripe wire from the igniters/fuel injectors (the wire branches out at the rear of the engine) but i can only see 1 wire going down to the plugs that would go thru...

have any of you guy's looked at the possibility that Hilux/4runner ratios will fit as here in Aus the axle code is the same as the MKIV supra diff. Just a thought that you may be able to try... as the hilux diff ratios are quite readily available.. good luck on your search