Search results

My car is getting manifold injected gas set up at the end of this month and i was wondering what you could use to control the ignition as the gas set up hs its own computer.. BUt how could you set the igntion computer up to only come on for gas and stay off when running petrol

should get yours checked it may be the answer to your nightmare

Much more power still a slight ping but no where near as bad, but while diagnosing the afm, i found the coolant temp sender was reading minus 28'c

yeah thats cool just like $10-$15 plus postage and its all yours

OK anyone who wants just the aluminum part and the honeycomb part seems in good nick its all yours for a packet of smokes or 2 longnecks

and by the way the reason i cleaned in because my k&n had too much oil in it... It was pre oiled when i bought it

Its all good i found a wrecking v8 soarer. The problem with mine when i put it back in i didnt line it up with the hole properly then when i tightened it back down i chipped the side off that circle part

I forgot to add check your junk mail folder or if you have high security filter it may of deleted your application letter

no i just mean the sensor not the aluminium body it hasnt been touched

mine came through in the time it took too type in hotmail

Can anyone tell me if just the black sensor from a 7mgte afm will run the car without problems i heard the electronics are identical, and iv got more hope of finding a second hand 1 of these

Cool glad i helped someone hopefully you get it

Theres one on www.importmonster.com.au for less than $1000 aud atm

I only need the black sensor but will buy the whole maf if need be, so anyone got 1? Preferably 1 hour drive either way of newcastle if not doesn't matter.

well today its a different story the car is in limp mode(wont go over 1400 rpm) i only unscrewed the black sensor and cleaned that, any ideas how to get it going again

Iv been told there are a few wreckers in Aus that do keep some lexus's but at the moment to me there just mythical creatures. Anyone know of a wrecker that would have 1uzfe powered cars in them in NSW preferable Newcastle, sydney central coast area. iv heard theirs one on the central coast but...

Havent got a pic yet, but i did take a closer look and i reckon i could pry it back out if i cut the single pipe out, or i might get one of the older more experienced guys at my work to heat and cool it see if that works but im a bit doubtful on such thin ss

Would that work well in your opinion or too hard to tell

Just out of curiosity, iv read People say dont clean the maf and others say you can clean the sensor. So whats the go with this, are you able to unscrew and clean the sensor only,(iv done this already and didnt seem to bother anything) Or when people say dont clean the maf do they mean the...

Yeah i gave up worrying about the car too and went to the pub and had a beer, I think canberra this time of years a bit hotter than Newcastle, And sorry i didnt mean the intake manifold i meant the air intake above the rad, should read my posts before i post them