Search results

What The remote Power steer pump off?? I have about 5mm clearance between my bango bolt for the hose and the chassis. Would it help me or do you think the motor wont move that much

Thanks for that , I,ve been thinking about plugging it off

If i'm running an aftermarket ECU (Linkplus), do I still need to use the vacuum lines from the power steer pump? I'm having a problem where the motor starts to rev up on it's own (possiable vacuum leak) and when I unpluged the two leads from the power steer pump and pluged them off, it made no...

Lack of fluid was the answer!

Tried that and it didn't move. I've Got Kdags controler but hav'nt wiried it up yet, But I would like to drive my truck on and off the trailer in the meant time and was hoping to do it just using the shifter. Do I need to connect only wires on the trans at all ???

Photo with belt in

100% correct I'm running an electric fan but have kept the pully that was behind the fan as an idler as well! does that make sense? Should I try and down load a photo?

I found a belt that will run alternator and power steer without the AC pump DAYCO poly-rib 6PK1575 Then it jumps up to 1600 long hope this helps others

I'll be there too if all goes well. Great way to share info Why don,t we make it a bit of a swap meet and take any adds and ends that others might be interested in. Dealers to mybe?

Someone with a workshop and lots of toys , A pub one side and a strip bar on the other!

Need a little help, I have got a Pricol Programmable Speedometer and a 1990 crown motor & trans. I was hoping that you would know what or how these go? Which one of the three wires from the sensor is the output?

Hamilton sounds Good, Just pick a date and do it. You won,t please everyone, so if you make a date and those who are keen will make it Rusty

Started Motor I've got About 70 psi at idle using 20/50 oil when hot, What oil should I be using or is 20/50 grade OK

Thanks to Gloverman WE got my 1990 crown 1uz (powered with a linkplus) going this weekend, It sounds Great, I just wanted to hear it running before I did the timing belt and water pump ect. I've got it mounted in a 1946-47 Jailbar, I'm waiting for one of Kdogs tiptronic to arrive. In the meant...

Thanks Very much

Its got 2 plugs 24 pin and 16 pin Part No. 89631-24010 It also has T R C written on it

Is that the cold start inj in the middle of the intake manifold?? if so I see the it has two wires , one goes to a temp sensor on the front of the motor(green) AND the other wire (black/white) goes to the same sensor but links off to a dead end (has been cut) 1990 crown I guess it would be the...

rewire 1uz Can anyone recommend someone in the Waikato NZ to rewire my 1uz. I have new breakout loom & Linkplus ecu. If not can someone tell me how many hours it should take for somebody that knows what they are doing to do the job. I plan on using the same plugs and sensors

Are there any filters in trans?

whats your radiator out of? can any one surgest a couple of radiators that will keep a std 1uz cool with an electric fan?