Search results

Finally got around to checking out my rad this weekend. It's a cross flow radiator with a core of 540w 450h and 45d. Interestingly the hose from the thermostat outlet goes to the drivers side tank at the top and the other hose goes to the passenger side tank on the bottom. Is this...

How big is the V6 tank? I still have the 2.4TD tank and got 350km recently of open road driving. Cheers Matt.

Nice looking truck! How did you get on for mounting the rad? Are the inlet and outlet in the correct position? Cheers

Hi Philip. The fuel level was getting low but I filled up and it didn't get any quieter. I currently have the stock diesel tank with an EFI pump mounted on the inner guard. Will the V6 petrol pump have enough flow rate for the V8? Cheers

Thanks for all the info guys. My truck seems similar, no vents or anything and it always sits on 87-90c no matter what I am doing except when I put it on the sand and then it gets real hot. I think I might flush the rad this weekend and check out the capacity of the radiator. Cheers Matt.

Hi Mudman. What did you end up running for a fuel pump and where did you mount it? My current pump is mounted in the engine bay and has started to get really noisy. Cheers Matt.

Thanks Guts. We weren't running that slow, I was in fourth gear in low range pulling low to medium revs. I will measure my rad on the weekend and post the specs here to compare with others. Cheers Matt.

My LN130 has a large aftermarket radiator with the two factory electric fans pushing through it. Normally the truck runs at about 87-90 degress depending on whats happening however over the weekend doing a big sand run the motor got to 110 and didn't want to cool down. I ran with the heater...

Ignore this, searched and found the info I needed. Cheers Matt.

Anyone done this before and know what needs to come off the top of the motor? I can't even see the starter! Symptoms are occasional hard cranking and only partial engagement. Cheers Matt.

Cheers Muzz!

Thanks Peewee. I have a front sump motor so will need the shorter compressor. Is there any way of telling if it's a shorter compressor or not - does anyone know the length? Cheers Matt

My air con compressor has been removed and I am looking to refit it so I can run onboard air for my tools and airlines etc for my 4x4. Does anyone know how the compressor mounts to the block, it's difficult to see the mount position and how it might work. I assume it mounts hard to the block...

Awesome work Mudman. Any update? Is the truck certed and running now? Cheers Matt.

Thanks Muzza. What model Hilux have you repowered? I don't have a W58 gearbox I have an R151 I believe so I don't know if a cable drive is available for the speedo. The cluster you got from a YN85 was it a carb'd or EFI'd model? Sorry for all the questions... Cheers Matt.

Thanks Muzza. So did you get a 4cyl carb'd dash cluster and are these cable fed from the gearbox for the speedo? Any specific model I should be checking for? I believe the LN130 has an electronic speedo so this would need to be changed. To correct the speedo with a cable fed unit are there...

I don't think I have ever seen an LN130 or equivilant carb'd petrol Hilux around. Over here in New Zealand they are all diesel or injected V6's. Has anyone used an injected dash and driven it directly from the Link? Cheers Matt.

Hi guys. Did anyone end up getting a factory tach to work in a Lexus Hilux? I have an LN130 2.4TD that has a 1UZFE in it with a big aftermarket tach on the dash. Also the volt meter, water temp and oil pressure are run from aftermarket gauges, the speedo is the only gauge working and it's...