Search results

Hi All Taken the old belt off and looked at the engine and thought it looked manky. so taking off the cam pulleys to clean up the metal plates for the plastic covers, you have to remove the cam pulleys, that's where the old belt comes in. Piece of tube 1 1/2", hammer and a M8 nut and bolt...

Hey George, you tried your shift kit yet. Alan

Had a good look and nothing, so all cleaned up and painted. Alan

Hi, are there any billet pulleys made for the 1UZFE, ie , idler serpent belt and cam gears. Alan

Thanks George I guess I need to get glasses. Thanks again Alan

Hi George Spent ages on there but no direct info, will wait until I pick up the box and see if it fits and the SC tc fits the flex plate, I can have the flex plate off the engine if I want so that could be the best option. Thanks for the reply Alan

Hi all Do the 4 speed and the 5 speed have the same torque converter ? Many Thanks Alan

Hi George Have the TCU for a 5 speed. Many Thanks Alan

Hi Will this gearbox fit onto a 1UZFE (1994 ) engine, I have a old 4 speed with the cable from the throttle, I think it's line lock up (correct me if iI am wrong). I want to replace the 4 speed with a 5 speed or even 6 speed if it's a direct swap. Alan

Hi Any body make blanking plates / covers for the distributers, I an using cop's so all the plug leads and old coils can go, just thinking it would look nice with cover plates where the old roters were Alan

Hi Try some of the mobility shops they do this kind of thing for disabled drivers, quite a few in the UK Alan

Thanks The Spitronic has only 1 water temp sensor (included with it) so all them can go Alan

Hi All There are 4 sensors on the front water bridge. what are they all for Alan

Hi Well first side came out ok, will be using 2 covers without the oil filler cap as the engine is dry sump and the filler is in the boot. Many Thanks for the picture Alan

Hi Just looked at all my plugs and wires on both the Mercury and Venus, all test out ok, have you talked with Peet who does technical support, always quick to reply and right every time (lucky guy). Which units are you using. Alan

Hi Was just going to leave them open, cam covers have seals in so just a gap to gather dust, guess it will not be a problem, only done one cover as yet, don't know if I covers will fit either side so they look the same, job for today fit it all up (have a few sets of cam covers) to try. Alan

Hi Made up 2 plates as your picture, going to fit them and see how much I need to extend them, tested the extension with a old coil and it works well on the scope so should work in the car. Alan

Hi Came up with a way to do this, made up a extension to the coil end, I found some springs that wind onto the coil spring just the right size, I have made just a loose fit test but need to mount the plate to the cam covers before I can get a exact size. Should do the trick, will use a high...

Hi Just worked out with the plate the cops will need to be extended, will look at this and show what I come up with. Thanks for the info Alan

On question, is there a cad file for cutting the mounting plate. Alan