Search results

I know, I know! OLD thread haha But, I just wanted to clear this up as I am buying the oil pump, tensioners, water pump, timing belt, etc for my 1UZ tomorrow and was hoping to save a trip to the Lexus dealer...I work at Toyota :) Thanks, Andrew

My fuel rails are square....

Well most likely, this engine wont see cams for a few seasons. But it will be seeing 8k revs sooner than later(stand alone ecu). It is an early 1uz and I have access to Toyota parts since I'm an employee :)

SO, since the last few pages of this thread aren't on subject... :) ...am I hearing this correct as a good combo? 1UZ Aftermarket Valve Springs 2UZ Retainers(bored to 6mm) 2UZ Under Bucket Shims Echo Buckets ? Thanks, Andrew

Did a compression check today....and it was LEGENDARY!!!!! FSM says 178psi is top notch. My SC with 272,XXX MILES showed between 160-170 across the board. SO cool :) Ready to pull it and install ACL bearings, ARP studs, and LEXTREME valve springs :)

Got my trans kit Friday! Thanks Brandon!

What is the current availability?!

Does the CSI feed come from the front crossover fuel line or the rear? Didn't see anything on the front line. May have to just pull off the manifold? I'll be doing that over the weekend most likely anyways.

Not much going on until I can sell these wheels... :/ http://www.lextreme.com/forums/showthread.php?t=14749

Very similar to Lowenhart LD-1s...

I have the cats from my '95 SC400. LMK! Thanks, Andrew

Picked up theses wheels not too long ago, just because I thought they are a rare find having been discontinued in 2007. These wheels were made by TRD specifically for the '01-'02 Lexus SC430, but will fit most any 5x114.3 lug pattern. These are 18x8" +40 offset. Due to the high offset, spacers...

That is correct. I also use dry ice.

First things first. The cats and the MAF have to go :)

No pictures to update with, but got a lot done. Finished getting EVERYTHING out of the interior and trunk. Hopefully I will start getting all the sound deadening out next week and prep for cage! In the following weeks I should have some updates that included test fitting the W58 kit with...

Yes, but after seeing the OLD group buy price down to $399...I don't want to buy them for the current $699 :) I'd rather pick up some good condition, used ones for the cheaper price. I'm cheap like that.

Hopefully I will have this thing track ready by St. Pattys Day!

I don't believe so...

Looking for a good condition, used set of 1UZ headers for my '95 SC400. Thanks, Andrew

The black interior must be in high demand, cause it is going fast! haha Also pretty cool that the gas tank location from the factory... Goals for this month: 1. Gutting and prepping interior 2. Fabricate an exhaust and intake system. 3. Pull and overhaul engine(bearings, studs, gaskets...