Search results

I have a Crown one. It will tilt the engine over at an angle though. If this is acceptable, it's your's. I am in Canberra.

Hi. As far as I know, there are two 1UZ auto belhousings. The tilted one from the Crowns (tilts the engine over to make it fit in the Crown body) and the straight one. Which one do you need? (Or better, what's it for?). Jeff

Ok. I want to remove the fan hub... I am dispensing with all the ancillaries, except the alternator. I am Ok with the fan... But I want to remove the hub bearing etc from the front plate. Cheers. And thanks for the reply.

YEs, I know it's been done, but the search keeps on bringing up blank threads (old??). Anyway, I want to remove the fan hub from my 1UZ that was in a Crown, so it has/had the viscous coupling fan. I have taken off the mounting plate, but apart from cutting the whole thing in 1/2, how do I remove...

No worries. Look forward to it. Cheers

So Chris (Does it sideways), How did it go? Did you have a go yourself? If it is ongoing, do you have any progress pictures or info?

Havent been on for a long time so scuse the ignorance, but as George R said, what is your system? I can assume off-road? Anyway, you said after the first few runs. Were THEY OK? Was it because the engine was cold, then perhaps overheating? Do you have a water temp gauge? What was it reading. I...

H Ash. I transferred the money for the engine mounts but it came back? Bank reckons the account number or BSB number might be wrong. Can you PM me with them again? Thanks. (Jeff)

Hi Ash. Can you check your PMs? Thanks.

Thanks all. I do appreciate the suggestions etc. All good info. Ash, email sent. Cheers. Jeff

Possibly. What does the actual rubber mount part look like? Thanks for the picture by the way.

Sorry, 1936 Chev roadster. With the box section chassis. The standard Crown mounts are a bit too far back so the steering shaft wants to go right where the engine mount is. If I can get a pair of those alloy mounts, and mount them so they point forward, that will give enough clearance for the...

Hi All: Mounting a 1UZ (ex Crown) into a Chev. Mounts are a little too far back, is there mounts that mount a bit further forward? Cheers

I could be wrong, but as far as I know, they ALL have a separate bell housing.

Would that be Toyota Corona's?...

Crown headers needed? Hi mate, I have a pair. I am in Canberra. Do you have anything you might want to swap? I am maybe after later engine mounts. Anyway, my mobile number is 0412105608. Jeff.

Some wiring diags Not sure if this will help Cliff. http://www.lextreme.com/forums/showthread.php?t=1004&page=3&highlight=uzs131+diagrams Along with the rest of the thread, or to go straight to the diagrams try: http://www.lextreme.com/forums/showpost.php?p=25058&postcount=39 I, too have a...

Hmmm. I am a lateral thinker... You said: "there was two girls in an Oldsmobile Alero".... And you WANTED to win? Why? More points if you LOOSE.....

Most cars of the 70's and 80's with carbies and electric fuel pumps used this technique. Some used oil pressure - which meant if the oil pressure didn't build up enough, there'd be a lag as the pump was switched off from the start circuit, and on again via oil pressure. Others used the...

Nice one. I wonder how many "dead" computers are fixed this way, after the unsuspecting customer has paid for a new one... (Then the old one gets resold as "reconditioned"?)