Search results

Well I know this has been a long winded project but hope to get it happening shortly. I have to modify the patterns before I get any more cast so would like opinions about the depth of the sump. From top to bottom it is just under 200mm. Is this too deep for most applications?? If so what would...

Maybe I should have read it all properly:eek::eek:. I was actually reffering to the original post which I now see was in 2008 lol. That'll teach me

How did you fry it??? Wired wrong???

So you've sorted the TCU problem then ?????

You better double check all your wiring and maybe a com port change to see if that sorts the problem out

Those figures look good for a stockie. What timing figures are you using to get the torque curve like that

Ive had mine fitted for over 12 months and many miles. Fired right up when fitted. Then just had to learn the tuning of it but had no problems at all apart from ones that I created by not knowing what I was doing

Why not just make a plate to fit where the oil level switch is

I have mine set at about15 deg at idle then ramps up to 38 at about 2.5k and have no det probs with any fuel. AFR's are all between 14.3 - 14.8. Yet to check WOT as I am low on points lol

Have you verified the timing with a light to confirm that its the same as software is telling you

Thought there would have been a few more lookers on there. Might have to link it to a few other places

Probably in the region of about $800. Still have to have a few changes made to the pattern for a baffle plate and also around some of the larger holes towards the rear.

Will try again with the pics:confused::confused::confused:

Well it's been a lot longer than I thought due to other commitments but have finally machined the 1st sump. As you can see by the pics I will have to make a couple of changes to the patterns as I have no lugs inside for baffle plate. Also have to miss 2 holes on the base without major changes to...

PM me your email address. Not sure how to put it on here

What part of the manifold are you after Vinniethespud

Cooooollllllllll:):):):):)

Might need to start something on their facebook page about a forum and see how many are interested. Might get them motivated to get their product out there a bit more

I did mention a forum or some dvd's of the training courses they have and they said they will be doing some you tube videos for their overseas customers. See what develops. The manual can be difficult to understand until you actually start playing with the program on the vehicle. Well that's...

Nice job mate. Love seeing anything out of the ordinary