Search results

Hey mate you won't find maps on that turbo, its an older design and hks doný release compressor maps for their turbos.

Yes we did, we are reving the motor to 7500 with an 1100hp turbo on it.

Hey just trying to find out if lextreme stage 2 cams for the 1uz will work with the 33% stiffer valve springs. Also will they work with a 2JZ bucket conversion? Has there been any before and after tests with these cams. Will they also work with the oversized lextreme vlaves, 1.25 and 1.5 mm...

and then!and theennnnn!

Thanks for that, the tomei gtr replacement pump uses 2jz gears in them.

Hey guys does anyone know the limit of the stock oil pump, with the amount of revs we can take the motor to. I would like to rev the stock motor to 8, but would like to know if the stock pump is as good a a stock 2JZ pump? Cheers

Thanks for that., Yeah Jake i was wondering what the top of the piston looked like, its all good thanks.

Hey guys wanting to get some sort of idea on how hard we should push our early model 1uz motor. We did make 363rwkw before but we would like to make 400-430. GT8 your about the only person in Aus that would have an idea? Also what have you done to your motor, valve springs? head studs? Cheers

Has anyone got some pics of the stock pistons and rods from an early model 1uz? Has anyone also got a pic with just the heads removed? Cheers

We found out that we had a head gasket let go. I've taken the heads off and we are deciding what to do now. But there will be more power involved!

Too easy, thanks for that! I'll let you know how we go once we have the new springs in and about 17psi cranking out of the T88!

Yeah i was after dyno results. Does it remove the lag you would of had?

Hi guys,I'm wanting to know if you can fit the lextreme valve springs whilst the heads are still on the car? I just purchased a set, and if they can't be fitted whilst the motor is in, they will be for sale again as its just not worth it for the time to take the heads off. Cheers

Have you got any results yet?

Can any help out here with real results, before and after dyno testing? Also who here in sydney can install and set these cams up for me? Cheers Ben

I've been thinking of doing a semi billet plenum for us 1uz fans. We would billet the plenum base and the injector mounts, along with the fuel rails and the plenum flanges.We would then just fab the top section and use one of our 90mm tbs on it. Have no idea on cost just yet , i would most...

Zuffen would you be able to install and setup set of cams for my customer?

DON'T make it our of stainless! one of the reasons is heat soak, plus you have to then drill injector holes and so on. If there is enough people who are serious i could arange some sort of group buy. just use a single 90mm tb if you can as its a lot easier. Cheers Ben

What are you doing with your setup and are you converting to shim under bucket and would you do it for someone else?

Whats the largest i can run? and who can put them in for me? Cheers