Recent content by williamb82

front seats, center console, trunk carpet, hood struts, and wood trim around the shifter etc.. are sold.

William Branan Spring Hill Florida whole car $2500 obo full engine setup with trans, all sensors, ecu etc... $1k firm (no parts from the engine will be sold seperate. its the entire setup or nothing. I will swap it into one of my supras if it doesn't sell) Front seats and console lid $450 obo...

lmk, and how much. its worth a shot. do you know what year it is from? 90-92 wont work.

btw, i have 8 of them

they are low impedance. and they have 4 holes in the tip so idk if thats what you mean by dual spray pattern or not. i know they are good to ~400hp with 6 of them on a 7mgte running a standalone. so 8 on a 1uz id say should be goo to 500ish. as for a trade, what did you have in mind? the only...

bump. i still need an ecu for my 93 ls400. heres the part numbers that will work 89661-50140 89661-50141 89661-50142

what size are you wanting? ive got some 440cc/min 7mgte injectors.

if the maf is bad, itll be sending the wrong amount of fuel to the engine and can cause the o2 sensors to foul out. might have to take them out and clean them once you get the maf fixed.

i sent mine off to A.T.E. to be repaired. they have failed, twice. before i send it back again i want to buy a replacement ecu, but cant find one for a reasonable price. local junkyard sells them "refurbished" whatever they mean by that for an astronomical amount. once i have a replacement ill...

id say ecu is hosed. with the tps unplugged the idl line should have 10v on it. problem with my ecu is with the tps unplugged my vta has 1.7v on it. seems the ecu's always fail in the tps circuit somewhere.

your situation is why i didnt buy a used ecu to start with and decided to have it repaired. well ATE "Automotive Truck Electronics" isnt able to repair it and i DO NOT recommend anyone deal with them. ive spent $100 for the repair, which doesnt work, and $45 on shipping so far and they want me...

btw, i am still getting errors 41 and 47. my problem is that the vta wire has 1.7v on it when the tps plug is disconnected. this shouldnt have 1.7v on it. the other 3 wires check out fine. vc is 5v, e2 is gnd, and idl1 has 10v. ive got a thread in the wanted section for the ecu. need a ecu for a...

not yet. sent the ecu to ate twice. second time under warranty. they havent fixed it yet. im trying to find another ecu so i can send mine back for a refund since they cant fix it. ive verified the tps and wiring are fine multiple times.

lmk the price including shipping to 34608 spring hill florida. thanks.

i still need a cluster. doesnt matter if the needles are dim as long as the speedo itself works. i need it for parts. lmk what you got.