Recent content by Toml

Nah, it's not okay. It "fits", but it doesn't fit correctly and doesn't let any air out of the struts. There's a rubber check valve in the opening of the connector on the strut, and the old air tube fitting doesn't extend far enough into the strut to release this valve. I'm basically looking...

OK I took a few pics with the new struts still in the car; hopefully we can see the differences. First, the front air tube connector looks like this: The old strut connector. You can see below that it only protrudes 8-10mm from the strut. Hopefully you can see here that there's...

I'm going to try and get some, but I think I'll have to pull one of the new struts out again because its too hard to see through the hole in the fender.

Hi all, Anyone aware of a change to the OEM Toyota air strut fittings/connectors? The car is an 89 UCF11 Celsior / LS400 -- I just replaced my front struts with brand new Toyota struts (same part number), but the air line fitting is slightly different and doesn't connect correctly to the...

Hi R-Jay, I've been following excitedly on Toymods - hope your project progresses smoothly. :) You're going to need two SM4's to drive that beast...