Recent content by Roga

Megasquirt V2 Thanks

The motor is a ucf11. Then loom is the only one we can find at the moment and we didn't recognize what it came from with these plugs on the ecu end of it, and we didn't know if it came from a vvti engine or not although the plugs all fit our engine ok. As long as we can wire it up the same as...

Do you know if it is off a sequential or the older version? All we have is the loom and want to see if its compatible with the ucf11 style engine and wire it up to an aftermarket computer. Thanks

Hi. Can anyone identify these plugs as to what model they came from and hopefully a pinout for them Thanks

Is there any real advantage to fine tuning your cam timing? I ask as I can get a set of adjustable pulleys and I am wondering if is is worth giving it a go........ Thanks Roger

Can anyone help with the pinout for the Ect normal to power wiring on a ucf11 with the 26-16 - 22 -26 plug type ecu The pinout is what I need as the plug does no have correct color coding Thanks Roger

Hi everyone My 1uz runs a bit rich and am wondering if changing the O2 sensors for another type or somehow tricking the computer will help It has the genuine loom uncut and the genuine computer (UCF11) Anybody tried this way ?? Thanks Roger

Yes the ignitors are earthed I have also tried another set with no luck I have no codes as I seem to be having trouble getting it to work I have hooked up a lamp with a 12v supply but cannot get any response at all Thanks

I have just transplanted a 1uz into an Isuzu Mu It is wired up ok I am fairly sure of that - it is wired as per the 2 diagrams on this site The engine winds over it has 12v at the ignitors and the diagnosis plug It has no spark and has 12v on both wires going to the injectors Is this a shot ecu...

Hi can anyone help with some advice please I am fitting a 1uz to a 1990 UCS55 Isuzu Mu This vehicle was Diesel Manual I am fitting the 1UZ complete with auto The auto is converted to 4wd using a transfer box from a Mu This has the advantage that the Mu transfer is completely manual and with...

Thank you very much for that info. Good News!

Hi, Can anyone tell me if the 1UZFE bends the valves if the cambelt breaks or skips a tooth ?? Just want to know as mine gets plenty of mud and I am trying to design some sort of washer system to clean out around the crank pulley area after use. Thanks Roger