Thanks Zuffen,
I’ll do that and check it out.
It may not be too bad.
It’s kind of like the old days on this forum when aftermarket parts weren’t available yet and everyone was innovating and building their own!
I still have Jordy’s original supercharger setup which has hand fabricated and...
Hi,
I have a 1UZFE in a ski boat.
It’s a stock early motor with the heavy rods and pistons fitted with a M90 eaton.
The blower locked up years ago and damaged the rotors and housings and put some metal through the engine. It still actually runs fine, but is starting to get a bit sad and has a...
Wow, didn't dealize that we had all these parts on the site. Will definatly buy them from David.
Terrific work David. Well done on setting this up.
Cheers,
Andrew.
Justen,
did you make the carbon fibre inlet manifold yourself? If not who made it?
I can't find any photos of it on here. Can you post some photos of it?
Thanks,
Andrew
Sounds like things are progressing well. Dellow worked out my flywheel and clutch and they did the job just fine.
Put a picture of you boat on here if you can.
Keep us posted!
Andrew
Welcome Craig,
Here is my ideas for you questions.
Use your SCM, just mount it somewhere it is not going to get wet. You can even place it inside something as simple as a plastic 'lunch box' with a wiring grommet to keep water out. That will keep you within your budget and if you can afford it...
Anyone know what is going on?
Has the dealership changed?
Richard Aubert is the original designer/ owner of Autronic (I was told). I believe he was originally tied in with the owner of Motec, untill a company split where Autronic and Motec evolved. Not sure which was the original company...
You may be able to use an adaptor plate on the mercruiser belhousing or the lexus one. Rolco Marine have fitted 1UZFE to sterndrive I think. They have a good range and knowledge of marine conversions.
http://www.kmrolco.com/
Cheers,
Andrew