Recent content by MattMc

  1. M

    Twin M45 charged 1uzfe project taking shape

    All CNC now, bought myself Turbo Cad and started with a square then a cube then a circle then a circle in a cube then a sphere in a cube and now this 8 weeks later. The injectors are water/meth. Regards Matt
  2. M

    Twin M45 charged 1uzfe project taking shape

    No data on the 12 core yet, but this 4 core unit was fully tested pre and post install. 26% power increases and 29% more torque. Were just about to install the bolt on version of it and start testing that. See link below. http://www.patrol4x4.com/forum/showthread.php?t=24057&highlight=laminova...
  3. M

    Twin M45 charged 1uzfe project taking shape

    Very nice indeed.
  4. M

    Twin M45 charged 1uzfe project taking shape

    I learnt a lot for the first one as did you. Is yours better hmmm I reckon they are as good as each other. As for the 12 core LS1's here are making over 1800hp but they are dyno queens. Keep up the good work, a close friend of mine here has just bought a kit and a 20v silver top for it...
  5. M

    Twin M45 charged 1uzfe project taking shape

    Hi Tom If we feed out vertically we come in around 438mm with these kind of end plates and only requiring one O-Ring to seal. We can reduce this too if required a little.
See more


Back
Top