Recent content by mark696

o2 censors do you need to run them , if you dont what happens ? im running standed computer and a 5 speed manual box if that helps?????

peewee are you running your o2 sensors, do you have to , what is best?????

thanks for that , i will give that a shot.

but there still must be a rule or guide to go by???

if i had the room to do that i probably would have ,anyway both sides match ,ands its at the least no worse than standed . what you guys need to do is set up a page on formulas to help people work this stuff out. it would be a great help .

thanks ,i used 44mm od 2mm exhaust tube,and copyed the lenghts off a set made for a soroar . i haven't had it running yet, so no dyno . i would have used the origanals but they hit my clutch slave , floor pan and lots of other stuff,i'll try and get more pics up as i fit up the rest off the...

here is some pics off my headers i made to fit in a nissan navara,i hope they work ok.

hay daver204 what radiator hoses did you use,and is that the standed radiator ?

heres a pic of the sump mod that i did . ive got heaps of pic just got to sort them out,

i tryed to find a rear sump but with no luck. i ended up with a mid sump that i changed by cutting the steel pan about 20mm from the bolting lip and slid it back to the end of the motor ,and cap the openings off .also extend the oil pickup to. it clears the crossmember and sway bar and steering...

cheers dave ,was your ute not injected,what did you do with the sump, did you massage the trans tunnel over at all, are you still running the standed auto and computer? im going to run the standed computer , i figure they spent $$$$$$$ on getting it right for it , why mess with it. thanks for...

hi dave ,can you post some more pics , im almost there with mine just got the headers to make, plumb up the clutch line ,move the battery, and get it wired, not to much to go but not enough time with work in all. cheers mark

has any done this yet ,keen to hear of any issues had while doing this swap,