Recent content by lux project

Interesting as I'm trying to clear the same fault code. So is there an easy fix, as it looks like throwing a resistor in the circuit wont be the answer?

The engine seems to run fine. this is during short local test runs, as I haven't got the ute legal yet, hopefully in about 2 weeks. So, if I reset the fault codes, nothing pops up initial. After a short drive, the cel comes on. I have a scanner so can pull the codes, and I get both primary...

Got a question on the best way of setting up the sub o2 sensors. I have the ole 'lets connect the subs into the primary's', and I think this is whats giving me fault codes on the primary's. This is fitted to the vvt-i motor. I have done a bit of searching on this forum, but can't see sure...