Recent content by Gertbuilt

I've got MS2 3.57 (pre assembed) and also have Tuner Studio. Have installed it with the Relay board. After carefully wiring up all the sensors Could not get an RPM signal on the gauge. Spark on one coil only. Heaps of emails back and forth to DIY Autotune trying different things and then...

It's been a while since I put my nose in here, but not much has changed. It's still not going and in fact I am unable to get past first base. Have been trying to deal with this in between other jobs and the technical adviser at DIY Autotune has been really helpful, but with no success yet...

I thought about the Hall effect sensors. It seems they are a much better option than the VR sensors. Thing is the ECU is specially set up to deal with the VR's. It has "Zeal VR conditioner" built into it that changes the waveform to a square wave that the ECU can use. I don't know if I can...

If you're ever up this way Crambo would love to chew the fat. I removed the VR crank sensor and measured the air gap to the trigger wheel. 1.7mm!. Since there is no adjustment, I carefully removed about half a mm from the mounting surface of the VR and put it back and checked the cranking...

Bought a new lap top just for the tuning. Downloaded "Tuner Studio" and installed all the drivers. Even bought a new wireless "Dongle" to connect to the internet. Crikey what a drama that was. Nine pm at the local Safeway supermarket, and the old damsel serving me wanted photo ID, and my full...

It's done now, but you're right, it would have been a lot less work, and I probably would also saved a lot of time that I spent researching which wires to leave out. Next time for sure.

Crambo I'd be happy for you to check out my project. I'm located in Wallan Vic. Where are you? HR lover I did what you said with the TPS and hooked up all but the "idle" pin. The relay board only has three connections for the TPS and I figured I could do without the idle fine control. The...

Hi All, Have been looking in here from time to time and have finally registered and joined you all. I am about to begin my eighth decade of being alive in one month, but don't let that fool ya. I still spend most of my waking hours in the shed building stuff. Have worked as a...