Recent content by ESPracing

I think you will find that copper pipe will have to much heat soak and a big down side is it is very soft oh and the price. If you have the bucks go ss otherwise go aluminum

Yes it does, rod's,valves,retainers,valve locks mmmmmm... so much titanium

Have you seen how little room there is bart?? I have the 1uz in my jza80 and we are fitting two y2k turbo's and let me tell you there isn't alot of room... I am ripping my hair out trying to fit them

about 10,000-11,000rpm

Then what kind of bearings would you recommend for very high rpm??

mmmmmm... Maybe I can look into machining up new ones in a selection of sizes. Just a wild stab in the dark but wouldn't alot of the standard 1uz use the same shim sizes?? Yes I know there are factory tolarances but they would have to be close to the same??

Isn't clevite 77 bearings used in alot of hypo engines??? Has anyone in Austalia found a good supplier of performance bearings to suit 1uz?? Or do we need to buy from the states???

Do 1uz really need to be reshimed all that often???

I not quite sure how you can organise a group buy when everyones requirements are different. Unless you get a group of people together with the same mods wanting the same results. I am in talk's with them now to have a set of custom cams made for my project, If you can come up with what type of...

Red supra, I have fitted the 1uz into my mkiv and I would like to use a turbo 400 trans. What parts are needed to fit 400 to 1uz bellhousing??? Does the 2jz flex bolt on to the 1uz then you need an adapter plate and converter?? what about tail shaft and trans crossmemmber and what do you use as...