Recent content by dwhe009

gidday, I have a 32mm garrett external wastegate and i am wondering if this will be large enough for my project? I have 1uzfe with master T70 turbo ... 0.68 turbine housing wanting to run 15psi. I will run a seperate 2" dump pipe out of the wastegate. I just dont want to get all the flanges...

cheers mate. anyone else?

Street application. Standard heads. Modified standard exhaust headers, 4'' exhaust after turbo. 3" piping through 600mm x 300mm x 76mm intercooler. Upgraded injectors. Link ecu. Hoping for around 500hp at 15psi. 200sx-v8 It's a while since I had this turbo, so it's a bit unclear in memory. But...

cheers both of you. But what turbine housings do you have and what rpm does it come on? 200sx-v8 "Now I use a Hks T51R Kai turbo, and that does not spool much later than the t70." - ok, so when? ozvenom "nd it just comes on boost so hard now and a good 700 rpm earlier" - ok, so what rpm? I...

anyone else experience this Master Power T70 with 0.68 A/R turbine on a 1uzfe?

and so... what a/r turbine did you have on the t70? and was the response 6psi at 3000rpm and 12psi at 4000rpm right in the meat of the compressor efficiency island as shown on http://lextreme.com/forums/showthread.php?t=1714

so 0.68 a/r turbine is the one you had and experienced boost first coming on at 2000rpm and 6psi at 3000 and 12psi at 4000rpm? did you then change turbo and why?

Anyone have any experience with this turbo on a 1uzfe? Lextreme, in your Project LS400T you seem to have a T70 with a 0.68A/R turbine and it comes on boost from 2-4k ... then all of a sudden in this article and thread you have a Garrett GT40 with Precision .68 T04E Housing and it comes on...

Hello, I have a dead stock 1uzfe out of a 1991 crown. It is in a single cab 1990 hilux and i have just about convinced myself to turbo it with a GT35/40R and run around 10-15psi on street gas (nothing wild) My question to you all after searching this wonderful forum is what a/r should i...

what do you mean "if its not raised" sideshow?

thats funny, everything i have searched said you need the rear sump??? is this in different models of hilux? I'm looking to get either a flat deck or normal 2 door ute 89-95. how does the driveshaft line up? cheers

yeah sorry, doing now

cheers, i'm in NZ, in auckland. Need a rear sump motor for hilux so soarer motor is the go... Just dont want to be trapped with wrong ecu when i want to go two turbos after a while and need to run a apex or something. And also dont want the soft slow shifts...

cheers, its just that the wiring diagrams for lexus and soarers have been not working on this site for a while. I only have have crown wiring diagrams and most people have used these for there conversions. Can people please give me advice/resources for when i go to the wreckers/imports? They...

cheers, its just that the wiring diagrams for lexus and soarers have been not working on this site for a while. I only have have crown wiring diagrams and most people have used these for there conversions. Can people please give me advice/resources for when i go to the wreckers/imports? They...