Recent content by Charedj

Thats a big arse increase in torque-but until the cams/heads/exhust have been done the curve is a bit crazy when compared with the horsepower. The iron block is certainly immpressive, even for the extra weight... I suppose the extra low end torque would sufficiently make up for that. If you are...

I'd just like to say how damn good that engine looks. Very nice man. Good luck with the ecu-I was to much of a wimp to plunge into a link straght off, so I found a crown ecu instead. Much respect towards you man.

Yuss! Good man.

Wicked ideas thanks xt-1, hopfully I can get hold of a good 6-lug at sum point.

Hey duda i'm currently doing the same thing-cept mines a B2000-not that itl matter in about two mounths. Perhaps we can help each other?

Hi guys, I'm Joe! I'm currently researching installing a 1-uzfe into a 1991 Mazda B2000 CabPlus(same as the courier basically) and this site is so useful! I have the car, just looking at engines now-and I think the engine bay will have enough room. Hopefully. Also have a 1991 Toyota Soarer...