Recent content by BLOWN22

Been a while since I last posted as I had a vacation free of cars for a few years but now back into it. I have 5 of these adaptor plates available for $250 US each Postage outside of Australia is $50 US

Thanks, I know these arent easy to get a hold of yet, so happy to help out

now on ebay, have made 2 more so have 5 available again. http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=110467288436 Auction price is $275, use make an offer button to get the $250 price as advertised in this thread. Cheers Jack

Long gone, sorry I dont reply earlier

I have been able to use this adaptor on a 1997 T56 gearbox right up to a 2005 T56 gearbox. I believe that T56 gearboxes all share the same bellhousing mounting patterns. They do however have different throwout bearing setups. One which uses a slave cylinder and fork setup and the other which is...

2 are now sold, only 3 left remaining.

I can get a part number for you, but I have used it with the GM T56 gearbox which comes out of the Holden Commodores in OZ. It uses the concentric release bearing setup. Here is a pic of the gearbox used.

I have had this setup behind a 1UZ with a 7.25 Tilton triple plate clutch. Just required a small spigot to locate the input shaft. Postage to the USA, you're looking at roughly $50 US

Hi all I have 5 adaptor plates for sale. This will mate the Tremec 6 speed T56 gearbox to a 1UZ, 2UZ, 3UZ etc... by simply using an auto UZ bellhousing. Might not fancy any one on here, but can also be used with 1JZ, 2JZ auto bellhousing to mate the T56 to JZ engines. Will ship anywhere...

Flywheels to suit 1UZ with a Tilton or Quartermaster 7.25" clutch setup. All are brand new and straight from the machine shop. These are used with the standard flex plate in place. I have 2 of them. Will post anywhere at buyers expense. Shouldnt cost too much, they only weigh 2.2kgs $275 each

For sale: Microtech LT10S ECU Item Condition: Brand New Never used still in wrapping Price and price conditions: $950 Extra Info: 1UZFE Base Map installed Comes with brand new; Microtech Loom Microtech Hand Controller Hand book Instructions and wiring Diagrams Had this for a project that...

this is sold peoples. thanks

Hi all After an auto bellhousing in Sydney preferably. Happy to pick up from anywhere in the metro. Live in Kingsgrove and wok at Bella Vista. Let me know what you have Cheers Jack

The sump you have pictured may work for me. It is very small though, so would need some work. Are you staying auto with the conversion or going manual? My front sump is currently fitted to the motor. I might be motivated enough to take it all off to explore the rear sump option.

have you got a complete rear sump setup to swap?