Here's most of what you need for a 5-speed swap. You get everything pictured for $500 obo. The bellhousing needs fasteners to hold the trans/adapter plate together. Also a little notch for the bottom bolt on input shaft seal. I can put it together for a serious buyer
Complete tranny setup to run 5-spd on a 1uz. You get the auto transmission bellhousing, adapter plate, shifter & transmission. The auto bellhousing isnt shown in the pic but you will get it. $650 picked up.
Have a R154 turbo box w/ an 1UZ auto bellhousing adapter. Bell housing shown on tranny is a junk 7M one. Shifter bushing is missing tho (usually worn out anyway) Came from crashed supra w/ real bad quarter panel damage. The thing pretty much looked this clean right out of the car! I did spray...
jus a funny side note... I removed the engine & trans from the LS today & both the engine & transmission mounts were completely destroyed!! just funny that everything was held in by gravity....
Ok cool. yea cutting the firewall seems a little excessive for what im doin... I had a look at my booster today and it looks like the lines go around the booster at like a 7 o'clock position. It looks like this might be a problem... I will be able to test mount the engine soon when I get my...
Im not doubting sideshows knowledge about 1uz swaps, but my confusion originally came from some of his earlier posts. I made this thread to TRY TO clear up all this.......