Recent content by Alan Whitaker

Hi Zuffen & Cribbj. Never been away look in twice a week, I got some bits from a guy who was on the V8.com but the machining was all over the place to say they were not usable is being kind, I have just finished a rebuild and was going to add a windage tray and scraper to the bottom end. I was...

I take it that's a no then

Anybody making stud girdles, windage trays and crank scrapers these days. Thanks Alan

Not with stock ones, I have seen someone bolt a pulley to the front of a stock one before

I have the Ross balancer, you can just add your drive pulley to it

Perth Australia

Hi All. Is there anybody in Perth running the Spitronics ECU and TCU with turbos. Alan

Thanks , I have a 4 rib pulley on the alternator. looks just what I need. postage would be to the UK Alan

Hi All Are there any serpentine aftermarket pulley tensioners so I can only run the alternator. Alan

Ok you will have to go on Facebook and type into your friends search bar 1UZFE V8 BUILDS & PARTS BUY/SELL/SWAP it should come Alan

Hi This is an example of the work they do. There is a thread re making a 1UZFE one. Alan

Hi Link may not work It's in the 1UZFE V8 BUILDS & PARTS BUY/SELL/SWAP Alan

Hi All This is on Facebook https://www.facebook.com/photo.php?fbid=10156146929735403&set=pcb.628612827241481&type=3&theater

Thanks George. Might just fit the kit and leave the holes. have a good transmission cooler as well. Alan

Hi All Just to bump this. Anybody done this as yet, just wanting to know if it's a good mod or not?. Have the kit on the bench and the box ready to fit to the engine. Thanks for any input Alan