Recent content by 1UZ-HZ

Got a disassembled 1uz out of 89 Crown. Includes engine mounts to suit Holden Kingswood. $500 4spd Auto from the same vehicle $200 Dellow bellhousing to suit GM 6cyl powerglide $500

Hey, I have to say that I had the same problem (90 model 1uz), it seemed though that the whole stud was too long...after cracking an inlet cam I found it also ruined the stud, it wasn't the nut or washer. I raised this issue a couple of years ago when the first lot of ARP studs became available

Would you be selling the "V8 Four Cam" Badge on the grille as well?? Mine went awol a while ago, and would look great on the grille of the HZ LOL

Damn, that sounds freakin awesome!!! I wonder if the road going version will sound like that?

You can use engine mounts from Castlemaine rod shop, use them with HK-HT-HG 308 mounts and it will all bolt straight in.

Mate, that is an awesome car!!! I love the colour!

Holy Crap!! I love that engine!

So is the VS a ute, sedan,wagon???

That's too easy, build the engine first.

Yep that would work, should fit no worries. Hmmm maybe I should have kept my VS hehehe

I remember a zoom mag with some shop advertising conversions with a VP-VR to 1uz conversion. I'm not sure if you can get decent headers in there, but it's always worth a try.

Ahhh just like the PWR setups for LS1's, pretty good idea I rekon.

They're Sold!!!

Bump $750...

I couldn't return a PM to you mate, just check your settings in your control panel, if no luck there just PM with your email address