If I were to do a manual swap on my vvti 1uz on a factory engine harness, would it drive ok? Would it throw any codes because the stock auto transmission was deleted?
How about for non vvti motors/ecu's?
what are safe/normal A/F ratios for our 1uz-fe's (non boosted AND boosted)?
at:
idle
cruise
wide open throttle
thanks for any all help!
where would you put the wideband sensor? since it's a v8 would i need to buy 2 wideband sensors and place them close as possible to the headers?
just...
can you splice a HKS super AFR (fuel tuner) into the 1uz-fe?
just curious, does anyone have the wiring diagram/ECU pin for the 1uz-fe?
are there any difference between the VVTi years vs. non VVTi ECU/wiring harness?
thanks for any/all help!
hi are there any uzz32's in the states??? are they legal and can it be smogged and registered here?
it'd be really cool to be able to test handle a uzz32 vs. a normal soarer...
bolting on a single turbo, what would be a better appliation to go with?
vvti or non?
how much can each motor support bone stock?
anyone think of running an HKS T51r SPL or KAI with the 1uz'fe's?
do you know if the normal 2jz-gte aftermarket cams would fit and work okay with the 2jz-ge (vvti- coil packs) head? i know the 2jz-gte cams would work on the 2jz-ge head (non vvti) perfectly fine...
curious if you can convert the non turbo (distributor) 2jz-ge head to a coil pack (like the...
is the sc300-400 axles' diff the same?
also does the supra auto diff pumpkin assembly fit in the sc300-400 perfectly? using the sc300-400 axles?
thanks!