I have a standard box R151F in my surf 1kz-te engine KZN130 (Turbo Box and gear driven transfer) input shaft length is 160mm, They have a different gear-set but pretty much the same box and from what I have read it will bolt up with your transfer case, can't find anything about R150F bolting up...
Hi Mate I've just done one, try here very good write up http://www.oldschool.co.nz/phpbb/viewtopic.php?f=2&t=29128.
Ps despite what you get told you wont need anything fancy for the fuel pump. just when you are checking the wire voltage for the fuel pump make sure you are cranking the engine or...
The transfer to 1uz engine and trans is the cheapest and easier option. fitting the transfer to the auto isn't really that hard at all. there are some pretty good write ups on it.
If you have deleted the tracton control and subthottle sensor you will get a code 47, What you need to do to clear the code is to earth IDL2 and bridge VC to VTA2. This should fix the code. cheers
Hi has anyone worked out the fix for this code? I have just fixed the fault code 47. but this one I don't have many pins left that it could be (if it is the hydro fan level sensor) .cheers
Can someone help me sus which wiring diagram I need. ECU #89661 - 50241
I think It's a 96. But don't know much elso. Alse I don't have the 28p plug for the ECU is that a problem? Cheers Dave