Recent content by 3barboost

hi - i have done a 1uzfe supercharged into a na miata about to do a 3uzfe (or 1uzfe) into a nb miata do have any pics of your build ? what gearbox ? the shifter looks spot on what mods to achieve that ?

all righty broad question for sure - some background I know the early motors are stronger - I had one in a previous project with a bullet supercharger kit on it I am leaning towards a 3uzfe vvti for the heads / intake manifold and small increase in capacity it will be mated to a manual...

It will be awesome I put a supercharged 1st February into a 1991 mx5 Do it !

i say go for the sumps - make them cheaper than the crs ones and make them hold a bundle of oil - like 8 or more litres plenty cars need a rear sump and oil pickup solution - i know the mx5/miata v8 swap crowd would be excited about an easy to get rear sump to drop a 1uzfe into the mx5 - I know...

550wnm 250wkw

hi petetas please clear your pms i cant send you a message

it is a nice setup i love the supercharger urge and noise i dont want to split up otherwise i think i will lose all value completely

ok here you go for pics on the car heres what you would get the supercharger, the idler pulley, the top plate of the manifold, the lower half of the manifold, the bypass valve, the throttle body, the back chamber of the supercharger, the idle control valve block off plate, various nuts and...

I am parting out the expensive bits on my mazda mx5 powered by a 1uzfe boosted by the supercharger I have an auto rotor opcon 3150 supercharger - just rebuilt when I bought it from richwood, this comes with the bypass valve / throttle body / tps / lower manifold / upper plate and the idler...

just push the SRC button a few times - it should cycle FM - AM - CD - AUX or just FM - AM - CD etc

pleasure, the other thing you can do if the radio doesnt have an aux input is get one of those fm modulators they all over ebay - they plug into the cig lighter - accept an mp3 input which is now the knock sensor and then transmit on fm I have bolted my knock sensor all over the place...

Hi - I normally tune subarus but on ym 1uzfe I have the copper pipe installed under the headers to one of the bolts on the engine mount to block I did try listen to each bank but then gave up and am using the passenger side bank I have also used the threaded holes towards the front of the head...

I use a set of ear muffs / ear defenders / ear protectors, then I buy a piece of copper piping normally found in the plumbing section, make a length about 8 - 10cm long, flatten one end about 2cm in a vice drill a hole through there - this will be bolted to the block, then get some silicon...

you need to listen for knock with your ears make up a set of det cans the knock sensos listen for a certain frequnecy of sound - that sets up a voltage the ecu determines that voltage on a pin = knock (super simplistic) trust your ears i bet its not knock can you adjust the sensitivity of the...

megasquirt actually has a specific setting for the lexus twin dissy motor and a number of people have used it sign up on the megasquirt forums msinfo.com i think and start reading there its a damn awesome ecu i have to say