- Messages
- 4,790
- Location
- Houston, TX
Thanks PWD & Scott, well it keeps the hobby interesting to try new things doesn't it?
I have a dumb Q for those of you who have actually finished your engines, or have a completely assembled motor sitting where you can look at it?
There's a set of three tapped holes on the outboard side of each head, just below the valve covers. Are these holes used for anything? If not, I may use them to mount my wiring raceway. Ideally I'd like to put the raceways inside the Vee, but things are just too crowded in there.
Here's the holes I'm on about:
I have a dumb Q for those of you who have actually finished your engines, or have a completely assembled motor sitting where you can look at it?
There's a set of three tapped holes on the outboard side of each head, just below the valve covers. Are these holes used for anything? If not, I may use them to mount my wiring raceway. Ideally I'd like to put the raceways inside the Vee, but things are just too crowded in there.
Here's the holes I'm on about: