Would be interested in knowing if you got this certed for the road and how many cm did you drop the crossmember?? I am doing a 95 wagon...at this stage working on 10 cm drop but bottom of crossmember getting a bit low to ground.
Also any chance of catching up?
Hey, Thanks for that....Regardless of my profile saying I am in Auckland...infact been in Whangarei for the last 5 years, however come down to Auckland lots. Best email if you make contact with him i [email protected] or mobile 027-6740993. I will chech out the other sites you list, however if you could dig him up would be appreciated. Did the car ever get certed?
I will do some more digging, but if not i will pass on your details when i see him.
When the car was being built, a certifyer was working in the same shop 1 day a week so i think guidance would have been given atleast, if not, it would have been certed
Hello, i built the legacy for a friend. I have not seen the car for a while so unsure if its been certified as of yet. The place where i did the engine conversion had a certifier working 1 day a week. He over saw pretty much all of the work that was done and was happy with it. But in saying this it was not actually put through the cert process when i last saw the car.
Thanks for that comment.
I am well on my way through the project...ended up dropping crossmmeber 100mm.
Cert guys up here happy at the moment
Regards,
Graham