Strip turbo ???

[XR8tt]

Has anyone used the S475 Borg Warner / airwerks turbo ???
T6 housing 1.32 A.R....
These are used on many 146 cube 4 cylinder engines with very little lag ...
Here's a clip http://www.paradiseracing.com/Media/Videos/Celica_755.wmv

As you can see very little lag.. I will have 2 step and transbrake also...
I would assume this would work well on a 250 cube V8 engine??

 

[JBrady]

No personal experience but looks like it would work to me.

Of course the 2.5 liter engines use the smaller A/R so on a 4 liter engine the 1.32 should be fine under the SAME conditions.

Since that is the least expensive BW offered by Paradise it is probably their highest volume unit (units sold)

http://www.paradiseracing.com/turbos.htm

The www.BullsEyePower.com site also looks very interesting!

 

[XR8tt]

Thats who I was going through..
There are other miketurboinc, Majestic and VSracing etc...
Have been speaking to Luis over my options??
They had high pre turbo manifold pressure with 1.01 AR on that engine
and went to the larger turbine...
In that vid clip it goes from 0-35 psi in less than 1.5 seconds!!! Then right after 60ft marker its at 55 psi!!! With bigger S480 ....1200 h.p / 800 rwtq
Motec controled.....