MAF Sensor (mass Air Flow)

[phillipguru]

well on my lunch break, i poped out the maf top sensor, and put it back on thinking maybe the seal wasnt good since the problem is intermittent, and you put it in, press it down, then i decided to make sure it was really snug so i pushed down firmly and wiggled it left and right and it popped down lower than it was, i drove it around and it ran fine, i think maybe the maf top sensor wasnt low enough in the chamber, but time will tell. It did go lower than i had it so im betting it wasnt seated and that was cause the randomness from intermit pressure drops in the swirl chamber