Help with reversing inlet manifold please!

[Rollux]

Hi all
Having some issues with reversing my intake manifold so the TB is on the left.
I know it's supposedly straight forward but I'm stuck as to what to do about this:
https://skydrive.live.com/?cid=3b6f...!cid=3B6F8F298818570B&id=3B6F8F298818570B!730

Suggestions?

 

[sideshow]

Can't access it due to fking gay windows live messenger or some shit
And I don't use it due to viruses
Anyway is it the plumbing or wiring

 

[Rollux]

Sorry, can't figure out why I can't post the pic direct.
It's the throttle body and flange on the upper plenum hitting the fuel rail inlet stopping it bolting down to the lower manifold by about 30mm

 

[gloverman]

Try turning the lower half of the manifold as well. Good luck. Cheers

 

[Rollux]

I have, but that doesn't affect the fuel rail location.

 

[gloverman]

Have you reversed the fuel rail too?

 

[Rollux]

Will actually make the problem worse as then the taller FPR will be in the road.
It seems odd - everyone says it's not a prob to reverse the manifold. Maybe that's only for the cast fuel rails not the billet ones?

 

[gloverman]

I have done a couple without an issue. Even think I have a photo somewhere. Im pretty sure I unbolted the whole unit as one and turned it around. Let me see if I can find photos.

 

[gloverman]

Photos

Photos of one I have done. Did it on the floor as I was wiring the motor at the same time which was easier on the ground. Hope these photos help. Cheers