Hello!
and i tried to run My 1UZ-FE VVT-i soarer with AEM EMS.
at the moment i have: all system are working well,
Engine is running well, but second (right VVT-i) is not working, but mechanically it works well
i can't find the mistake in cal of AEM EMS. (wiring checked number of times, hardware mods were made in AEM - i am an engineer and know how it works)
the engine has full stock crank 36-2 sensor and stock 3 teeth cams.
stat synchronization well.
what did you done to driving both VVT-i???
may be you modified cams from 3 teeth to 1 tooth?
please send me your cal file if it is possible
(PM for email address)
ps: i wired left cam sensor for CAM, right sensor for SPEED (AEM user guide)
left VVT solenoid for INJ#9 Right for INJ#10
pps: please find my general settings in attachment
best regards, Alexander
and i tried to run My 1UZ-FE VVT-i soarer with AEM EMS.
at the moment i have: all system are working well,
Engine is running well, but second (right VVT-i) is not working, but mechanically it works well
i can't find the mistake in cal of AEM EMS. (wiring checked number of times, hardware mods were made in AEM - i am an engineer and know how it works)
the engine has full stock crank 36-2 sensor and stock 3 teeth cams.
stat synchronization well.
what did you done to driving both VVT-i???
may be you modified cams from 3 teeth to 1 tooth?
please send me your cal file if it is possible
(PM for email address)
ps: i wired left cam sensor for CAM, right sensor for SPEED (AEM user guide)
left VVT solenoid for INJ#9 Right for INJ#10
pps: please find my general settings in attachment
best regards, Alexander
Attachments
Last edited by a moderator: