Search results

Hi all, Has any one managed to stop torque reduction on gear shift with standard transmission and computer. I have manipulated shift points full and partial load but would like to stop timing from being pulled on gear change which is slowing vehilce down.(slightly) My engine and trans are from...

Ive finally got some pictures of my blower and intercooler, still have to connect radiator for intercooler and then get dyno tune. Fells pretty good with the tuneI have done so far, doesn't look great but should work good when finished. Traction from take off already lacking so should be fun...

Hi everyone, I have finally got my m90 1uz up and running, needs a tune as blows black smoke and missfires under heavy load. Im using 330cc injectors from 7m (green), rising rate reg (250 kpa base), and SMT6 piggy back ecu. Yet to hook up radiator for ATW intercooler but hope to get some...

Hi everyone, Just wondering what boost pressures are being achieved with what pulleys when using M90. I know there is a lot of info already on this site but don't know whats correct. I have ordered 65 mm pulley from BULLET who tell me it will only run 6-7 psi. Other info sugests the boost...

Hi guys ! With my blower installation I will need to move thermostate housing and make change front water bridge also for clearance reasons. My question is does anyone know whick is water inlet and outlet on 1UZFE? Normally it would be inlet or suction at water pump and outlet at top hose or...

Hi Guys I was wondering if any one has or knows where I can get M90 outlet as used on Thunderbird,I have blower and inlet but no outlet and having one will reduce work required for my conversion. I have added picture from ebay of supercharger with outlet that is needed. Supplier of my blower...

My M90 has 8 rib pulley and is 2.8 inches accross where belt contacts. Is this pulley standard as apparently 6 rib is on M90? Are the pulleys measured on the very outside edge or where the belt runs? I am trying to calculate what boost this will generate and was wondering if using intercooler...

Hi guy's. This is my first entry into any of your forums, I have completed conversion of Crown V8 into my Courier space cab (using your info for ideas)and am now getting parts together to supercharge it. Have got M90 and water to air intercooler, need lower half of manifold to make my own...