Search results

Hi i am after and aircon compressor for the 1UZFE that is located in Sydney please send pm with details. Thanks John

Hi I need to find both the left and right engine mounts i am in Sydney so would prefer if someone in sydney has them please pm me with price and location Thanks John

HI I need an AFM to suit 1989 Crown 1uzfe, i need asap would prefer it to be in sydney that i could pick it up Please send PM if you have one available. Thanks John K

I found a good place to access online lexus manuals http://www.alldatadiy.com/ you have to pay but the price is very reasonable $24.95 USD for 1 year access for 1 vehicle $14.95 USD for extra vehicles You can print everything you need off the site so technically you can get the whole...

I had the exhaust fitted and drove the car home (first drive), engine seemed to be running fine except it didn't like to come back to idle (would stall if the engine revs weren't slowly brought back down) and the motor was running very rich. the following day while driving the engine stalled and...

I have just discovered that when i followed Zuffen's wiring guide for the 1UZFE his guide say's to cut the blue white wire in the 16 pin plug this wire is the wire for the TE1 terminal in the diagnostic connector so you may need to reconnect this wire if you happen to cut it. if you check the...

Hi, just got the exhaust done on my enigine conversion (1UZFE into a 84 4Runner) when i turn the ignition on the check light comes on (as per normal i would think) then you start the car the check light goes out (as per normal i would think) the after car has started and is idling away check...

I don't know if this has already been posted some where but a friend has the 4.7L Cruiser and the oil filter it uses from factory is a short oil Filter with the Ryco part number Z418 and it lists the 300, 400, 430 and 470 on the packaging so anybody looking for a oil filter this would be a...

Hi, What sort of pressure is needed in an after market fuel pump for the 1UZFE. Thanks John

Hi, i have a couple of questions regarding wiring. 1/ the black/white stripe wire from the csi (cold start injection) temperature sensor, is this a ignition fed positive or is this wire a ground? 2/ the wiring to the throttle position sensor 2 (i.e the one connected to the opposite end of...

Hi, need to know what this part is.. the first pic is a closeup of the part i am asking about.. the second pic shows overall view to show where it is... is this part of the traction control system if it is not part of the traction control do the wires need to be connected if they do...

hi where on the 1990 crown 1uzfe is the temp switch ( i know it is at the front left as you stand in front of the motor facing it) and is it just a single wire or is it 2 wires.. if it is 2 wires what colour is the plug Thanks john

Hi I have just bought a 1990 crown engine and just need to know if what i am thinking is right.. i am following the black/orange stripe wire from the igniters/fuel injectors (the wire branches out at the rear of the engine) but i can only see 1 wire going down to the plugs that would go thru...