Recent content by rscob

Thanks for the fast reply but i already have them fitted to the bearing its the fitting size from them to make up the lines,doe's this mean the thread size is m10x1.5 that i need . Cheers rob

Can any of you guys tell me what type of fittings are on the t56 throwout bearing i think they are an4 7/16 thread as i need to buy the fittings to make up my hydraulic lines. Cheers rob

Yeah tell me about it,if i buy your t56 adaptor plate at a $106 your shipping is $262.10 to ship to the uk:eek: whereas xat will ship it for $50.00. Rob

Has anybody had any dealings with this company as i need a few parts for my 1uz-w58 conversion,i have tried 4u2quick on here but the shipping was more than the parts i wanted to buy:confused:. Cheers rob

Hey guys can anybody tell me which clutch to use on my 3sgte flywheel with w58 gearbox fitted to a uz,i was thinking of using a toyota4 runner 3.0 v6 cluch and pressure plate or maybe the hilux clutch setup doe's anybody know if this will bolt onto the flywheel,and also is a 13x32x10mm spigot...

Cheers ivan.

I have a ksracing flywheel ready to fit onto my 1uzfe and i need to find out which clutch i can use with my w58 gearbox as its a 10'1/2'' face on the flywheel:confused:. Rob

I have done away with all the egr stuff and relocated my oil filter because of space issues,but on the thermostat housing i have a water take off that used to run through the oil housing then onto the side of the block question is do i still need to connect this up or can i blank both ends...

Cheers for that,i now know what i need to do:). Rob

I have a t56 tob and am looking at fitting it to my w58 gearbox thats using the 1uz auto bellhousing with an adaptor plate to mate upto my 1uzfe engine,it looks like i need to cut the w58 35mm input shaft off as the t56 is 30mm then make a plate to fit and mount the bearing on,has anybody...

My 1uz 1992 with the 26 16 22 26 ecu ,when ignition and key removed the engine and fuel pump keeps running,i have wired it with the 3 relays and wires from the ecu as per the tonyd wiring diagrams it fires and runs fine but i cannot shut the fuel pump or engine off unless i pull the fuse...