hrforever
Member
- Messages
- 196
- Location
- Melbourne, Australia
I'm part way thru sorting all the wires and plugs for my MS3 V3 with MS3X expansion board and was wondering about the 2 knock sensors in the valley of the 1995 1UZ motor. Are these used/connected to the MS3 or does the newly released knock sensor module have to be bought to handle this?
This link shows the module:
http://www.diyautotune.com/catalog/...ontent=Newsletter28&utm_campaign=Newsletter28
This link shows the module:
http://www.diyautotune.com/catalog/...ontent=Newsletter28&utm_campaign=Newsletter28