Jordy,
i have a 1uz vvti on the way. i am able to modifiey the bellhousing to fit the omc stern drive in the bayliner its going in but i am not sure on the fly wheel mods. how did you do it? did you remove the gear tooth of the flex plate from the original factory auto or did you start from scratch.
also where did you buy the heat exchanger from and how much. i still havent seen any photos of your blown install yet, is it finished, and what speed did you get?. Should i do anything to my motor before i put it in, timing belt? water pump or pulleys?.
Many thanks
Paul
(Bayliner 1uz install)