Recent content by EXPIG

Looking for Power Steering Pump, Suit 1UZ-FE. Located in Melbourne

Sideshow Just to clarify, yes I bought a complete Celsior 1/2 Cut, Engine, Looms and Auto are matching. Car still drives fine with the error codes, I will look into clearing them tonight & see if they pop up again. As for Error Code 56 I think I will just throw in a resistor to the...

lol local lexus apprentice would'nt even know where to start Fault code 46 No. 4 Solenoid Circuit, according to mitchells on demand

Sideshow My OD light is not flashing on the dash so I am assuming it works I am getting my check engine light only, but not all times. Any Ideas on the 4th solenoid issue and secondary throttle? ..............if only you were based in Melbourne At least it's going One other thing I...

After 500km of driving, I have the following issues: 1. Error Codes Engine 47 & 56, Trans 42 & 46 47 is something to do with sub throttle position sensor (I'm assuming trac control) 56 I read something about Hydraulic Fans????? 42 Has something to do with Speed Sensor 1 not been the primary...

Update Finally got the UZX83 going, it has taken a whole 4 months, but I cant wipe the smile off my face. I would like to thank, the following forum members for all there help & advice: Sideshow, Macrop, Peewee & Madmont You guys know your 1UZ's. I will try and get a step by step...

As per our discussion earlier There is definetley +12V ign power to ISC valve, therfore I am assuming there should be power to transmission. I did not get a chance to check if SP2 was plug in, will try and check it later on tonight. If I get a chance I will also check for any codes that may...

Sideshow I used the engine & matching gearbox, I retained the original rear transfer case/shaft & used all original sensors. With the exception of using a Hilux fixed flange. The 2 wire speed sensor you speak about, is that the one at the front or rear of the box? I am under the impression...

A bit of an update, I have since my last post got fuel pump & NSW to work correctly. The car runs & drives however I have the following issues: 1. The transmission is stuck in first gear & will not change into any other I have not wired in the speedo drive to my dash (grande) which in...

cheers that would be great

Sideshow I am so close to finalising this conversion, but I am doing by head in. I am stuck...............could you please identify which wires form part of the Neytral Sfatey circuit? and which wire do I need to bridgr to keep the fuel pump running. I can get the car to start but it will...

Could someone please identify what these plugs are labelled & if their are pinouts for them. they come off the main ECU harness & I am assuming most of them go off into other ECU......such as trac, ABS...etc Please HELP

looks like it may be my only solution, would be good if the 4 runner item has the same spline though

I was thinking more along the lines of this part

Question I am trying to locate a 4 bolt or similar fixed yoke flat flange to replace the 3 prong on my A341E. This is the last piece to my puzzle Does the 4 runner or Hilux transfer case fixed yoke flange share the same spline? I do realise that it may be slightly different in OD and...