Recent content by t671200

SOLD SOLD The car is now sold it was fun but a offer too good to refuse was made now I can finish my ute. Nick.

:1zhelp: Bought an Autometer electronic speedo it has a signal input and output what would I connect these to on my HR it has a 92 sc400 engine and computer , this is one for the tech heads. Any help appreciated. this is the instructions from Autometer can anyone help ...

Swap Oh well good luck as other peoples input will be invaluble in this project and test many friendships all the best need help let me know there's over 300 photos of my swap . Nick.

sump Drew: I'm pretty sure their front end is designed for front mount rack and the sump is HQ type rear sump setup correct me if i'm wrong , so your pretty much set in that way you won't be running rear mount rack's as their is no room for it ie : the sump will now be in the way , and the...

Price And a sump kit as well more $$$$:pokey: Nick.

crossmember Awww c'mon do your own crossmember as CRS is a bit $$$$ :Eyecrazy: then add the rack kit to it as well up around 1500 - 2000 mark. Doing it yourself you will only be up for the rack kit , it only needs a simple scallop out of it. Nick.

headers The headers are still original at the front 2 ports it is the back 2 that were "tucked" in it would be no more than .5" the only reason for this is to sit the engine low enough and to clear the chassis rail as they are so close together , the column drive is exactly as it was for the...

radiator no, it holds water just fine Nick

more updates Had one of the gearbox solenoids go on me leaving me with only 1st & 2nd gear:damnit: replaced them and all is fine still need to do the shift kit though . got some whitewalls done on the tyres and a new radiator cap ! , exciting stuff I know . Is it a common thing for these autos...

pictures first is of the car ( needs a wash too busy driving it to care) it may not look low but it is almost an 1" off the bump stop it is just the dia of the wheels that is decieving. second the column indicator and guages third the overdrive switch where the choke used to be

Diff the HR has a offset tunnel as well it is not a problem as Craft diffs here put me onto the R31 diff as they said it was less work involved in fitting , but it did throw me off a bit when i was doing my exhaust as it didn't look right ie even took a few measurements and thought the car was...

Diff By the way use a R31 Skyline diff prefferebly the Silhouette one as it has 28 spline axles lsd and decent discs and the added benefit of easy handbrake cable hookup it is only 15mm longer than the stock HR so 7.5mm either side it will only need the brakets removed spring hangers welded on...

Ratio Don't know exactly what rpm's it's doing at 100 as i am still waiting for my Autometer speedo to turn up but it doesn't sound too revy keeping up with the traffic to and from work will let you know , but isn't the stock soarer ratio 3.9 ???? is this correct anyway with the 285/30/18 it is...

HR Now you're just being cheeky Nick.

Fun Been driving it for the last week now it is getting better had a miss in it still using the shitty old leads from the damaged car so ordered some new plugs and leads , waiting for them to turn up it sounds good the more you get into it , the shift leaves alot to be desired , oh well it was...