Recent content by MrE

Cheers Kelvin, E-mail sent:D Mark......

Posted this in the problem section, but thought I'd pop it in here as well just in case...... Hi All, Having a problem with my LS400 engine I've fitted in a LJ70. Before I removed the engine from the LS400 it drove fine with no problems. The problem I had initially was with the engine...

Hi All, Having a problem with my LS400 engine I've fitted in a LJ70. Before I removed the engine from the LS400 it drove fine with no problems. The problem I had initially was with the engine 'looping' at idle (rev to 1200 then back down to 400, repeatedly), I overcame this by fitting a...

Yes mate, it gets used for all sorts of competitions:) It took about a week to remove the 2L-T (boat anchor) and fit the 1UZFE and 3 months of weekends to get it to where it is now! the wiring was probably the worse job:frown: Should be done (or ready to drive) in a couple of weekends and yes...

I'm just coming to the end of my LJ70 V8 & truck cab conversion, to buy the coversion kit over here would of cost me $3200+ :eek: but I got a clutch, flywheel & R151 to 1UZFE adapter plate from NZ for £650 :) I had to mod the 1UZFE auto bell housing by grafting in the clutch apeture and slave...

Thanks for all the replies guys, will get onto it as soon as I finally get the, pump, radiator, igniter's and MAF sorted so I can connect the battery's and get her fired up:) Cheers muchly Mark.........

Hi Guys, Putting a LS 400 V8 in my LJ70, I would like to use the oil sensor thats in the sump and wire it to the now unused glow plug light in the dash. The sensor has 2 wires 1 brown and 1 green/brown?, do I give one wire 12v feed then use other wire to power the bulb, or is this another...

Hi Guys, Putting a LS 400 V8 in my LJ70, I would like to use the oil sensor thats in the sump and wire it to the now unused glow plug light in the dash. The sensor has 2 wires 1 brown and 1 green/brown?, do I give one wire 12v feed then use other wire to power the bulb, or is this another...

Looking to do the same with my 1990 LJ70 Land Cruiser, will probably have to have a look on either an Aus or NZ site, as I don't think they had this Cruiser in the USA:rolleyes: Mark.....

Hi All, The names Mark and I'm from Kent (in England), I'm looking to rip out the Ol'boat anchor (2.4 diesel) and fit one of these fabulous V8 engines into my LJ70. I was hoping to fit it with the auto box, but after a quick look-see with the tape measure, this isn't going to happen due to...