Recent content by M3TURBO

Not necessarily, High resistance roller setting, will not change your HP figures, if anything it might actually improve dyno HP numbers! Modern dyno’s like this compute wheel torque against engine RPM to arrive at HP, it doesn’t matter if you are in 1st gear or 6th + overdrive,. And again...

broken rod/piston Looks like the piston overheated at the top, expanded, tried to sieze and was then pulled apart, the rod broke as a result.

Sorry to hear about that, though I tend to agree with JustenGT8, I ran stock rods at upto 20psi with a large turbo regularly but not over 6500RPM, it ran around 550 HP. No problems with months of thrashing on the street. You can see in your picture where the piston has impacted on the squish...

Iv'e Just seen this thread, the 880 HP run was done with the stock intake, I have a short runner style fabricated intake under construction, hope to be finished soon for more testing. Looking for a bigger turbo too.

Fasteddie, Cams are 272/272. Re: stock intake, why surprising? Torque curve or peak torque? Though I am pretty sure a short runner new plenum will keep VE and torque up above the 6K point. Fueling requiement is down above 6.5K on this boost level but that also could be due to the small turbine.

For JBrady, re-post of dyno pull notes. Notes about this run: Not a particularly good pull, we had a tire slipping problem, can be seen on torque sharp dips after 4.9K. Damaged a tire on the dyno so could not do further runs at this session. Having to use a high gear, Dyno speed limit was...

The Intake manufold is still under constuction, might be at least a few more weeks.

Nice, I admire this kind of commitement. What kind of boost & HP are you expecting to run by going to this level. In your experience what was the issue with the stock block, head seal? or general block integrity, not enough meat for big studs, block splitting apart etc? Ever thought about...

No, that won't have issues. But no water passages, 1/4 mile use only, no street use, right? How much ? Availability?

Thanks Ed, Interesting, it looks like the big bore sleeve mod is not quite out of the experimental stage. I believe once it is sorted higher boost levels may not be an issue.

Thanks for the prompt info, any more details on exactly what "little issue" was wrong with those sleeves? BTW I don't mean the stroker version, I just mean an over bore re-sleeve build, so we would have a 4.7L motor and with stock crank. The pistons would be custom and dished to obtain 8.5:1 CR...

Hi David, Wonder do you or does anyone already have the 1UZ @ 3.75" - over bore motor running relaibly on boost, preferably say 26 psi up? Before attempting, I am considering head gasket seal relaibilty. If you look at the 1UZ heads they measure 105mm between water passages, so we only have...

I purchased the short runners from Damian at a1turbos in NZ www.a1turbos.co.nz Though I will need to fabricate the plenum section myself.

I take it your 7/8" is a typo. I used 7/16 ARP studs for this motor. I have 1/2" ARP's ready for the next build. IMO, 75 - 80lb is about the safe limit for 10mm ARP and the block threads