Jim - I have wired it to the back of the speedo head
I have not done anything with the neutral start wiring
It has a manual behind it and I have wired the starter straight to the starter relay in the factory fuse box
Are you suggesting that I need to put 1 of the shift solenoids to earth?
I...
I have hooked it pin 2 in the smaller e9 connector - spd speed sensor 1
if it was the number of pulses from the vss, why does it do it in every gear regardless of speed but directly relational to rpm?
1992sc400 with 40 40 40 pin ecu
I have put it all into a Hilux
I had a few dramas with knock sensors
Firstly new dead sensors then wrongly boxed sensors
But finally sorted
I now have a 3750 rpm rev limit
It will rev out properly sitting still
It has a manual gearbox behind the motor
If I...
rather than start a new thread
code 52 55
I have replaced both knock sensors
I have checked continuity from the plug at the back of the motor to the ecu
I have not checked it from there to the knock sensor but it looked fine, I will have to pull the manifold off to check that
and have...
hi
it doesn't run bad - runs pretty well
just the light is on
they were replaced by a mate who works for Australian computer co
one of the injector driver tracks was damaged but has been repaired.
neil
hi all
to start off 92 1uz into rzn 149 hilux manual not auto
I have the motor running well but code 42
I seem to remember reading somewhere to put pin 76 to ground
nothing else for this?
I also have codes 52 and 55 but I hope that they will be just be a tank full of 2 year old fuel for...