Recent content by gennro

  1. G

    Wanted WTB 1uz water neck

    Autozone sells them for like 12 bucks
  2. G

    5SFE pistons into the 1UZFE

    I believe the 3S is like 82 or 83mm. Yes. the 5Sfe is a 9.5 CR stock.
  3. G

    5SFE pistons into the 1UZFE

    So has anyone heard of anyone using 5SFE pistons into a 1UZFE block. I have been looking around and found that the 5SFE piston is really similar to the 1uzfe piston. The 5SFE is 87.5mm bore with a 9.5:1 compression, .866 pin size, and is a dished piston with 4 valve reliefs. Also it is rumored...
  4. G

    carbing a 1uzfe

    Don't waste your time. Unless you are running racing it and you can only run carbs in that class.
  5. G

    Engine mounts

    Check these guys out. A little pricey but they seem to make some good products. Its mainly based on MkIVs though. http://ttcperformanceproducts.com/
  6. G

    1uz in to 2nd gen surf

    My auto works in my 2nd gen 88 truck 4x4. I'm using the A30-41LE from the sc400 and swaped the output shaft from a A30-80 4cyl 4x4 with a VF2A transfer case. Now i couldn't get the VF2A transfer case to work at all so I just used the forward transfer case housing and used Inchworm gear adapter...
  7. G

    Standalone ECU The right Standalone ECU for me

    You know throwing money at problems won't fix anything. I would take the car to a reputable dealership and get the problem fixed before dumping any more money into an unkown problem.
  8. G

    Standalone ECU The right Standalone ECU for me

    There is a difference between Limp Mode and Backup mode. Limp mode is a set of codes that will cause the computer to into a limp mode till the problem is fixed. Backup mode is where the computer will run on pre determined settings and will let the engine run but at 5 degrees BTDC and will...
  9. G

    Standalone ECU The right Standalone ECU for me

    Your ECU is bad. It is running in Back-up mode which usally means the ECU is shot. How I know this is if you can disconnect the MAF and the engine still runs and revs means it is running in backup mode. Also the timing will be set at 5 degrees BTDC and will not advance. I had the same problem...
  10. G

    right transfer case for the lexus tranny ?

    Hey man, the best route probably is the adapters from inchworm gear. I'll have mine next week so i'll post up some pics and results of it next week on yotatech.
  11. G

    1UZ - W58 Adaptor plate Teaser Pic.

    I would defintly be intrested in the W58 adpater and the flywheel. I want to do a 1UZ swap into a 1982 Celica supra next year.


Back
Top