Recent content by cation

SOLD to Peppo!!!

Cleaning out my garage. I bought these for an S14 project to make my own headers that I have since completed, lost interest, and sold. Forgot I had em... $60 plus shipping OBO.

Oh yeah, I almost forgot that I have a spare PS pump too, but it doesn't have the reservoir...

I've got spare igniters, spare coils, and a set of plate steel header flanges that were made for a custom header application that I never finished before selling the car. I've also got a 97 MAF I believe if you are interested. PM me or email me at gjlepeak (at) hotmail (dot) com Thanks!

I think I may still have one of these. Email me at gjlepeak (at) hotmail (dot) com if you still need it. Or just reply to this PM. Thanks.

I bought a set of these for my 240sx project. Unfortunately I could not get them to fit since I didn't want to hack them up, but they are actually very good quality for their price. I have them collecting dust right now. If anyone may need them let me know. I'll let them go for dirt cheap...

In my case the SC400 sub harness on the engine had a two pin connector for the coil and a six pin for the LH cam sensor, crank sensor, and hydraulic fan pump solenoid. The LS400 harness will have a 4 pin connector where the 6 pin connector is on the SC400 if memory serves me correctly. I had a...

sideshow is right on about this. The starter solenoid wire/knock sensor harness connection is slightly different as is the connector at the front left hand side near the injector. I know this first hand as I'm using a SC400 1UZ engine with a LS400 harness/ECU in my 240sx project. We just got...

Parking the 240 this weekend and starting the swap. Here's some pics after degrease and pressure wash:

I have a primary TPS sensor from a 93 LS400, but no plug. Let me know if you are interested.

So I went to junkyard this afternoon to pick up my motor set... While there I randomly started talking to another customer who noticed the motor I came to pick up. As it turns out he had a 1UZ out of a 97 SC400 with 90k on it that he was going to swap into his MR2. He informed me that he had...

Thanks for the advice! The goal is to cut/solder/splice wire looms as little as possible. I like to keep things as clean and as "stock" looking/functioning as possible, but I do intend to do exactly as you recommend with the EFI and fuel pump relays. The Nissan speedo is run directly off the...

No worries man, I know all too much about how that goes. Thanks for the reply! I sent an email back.

Found the 96 LS400 wiring diagram for the ECU. Should have searched first before asking.

Awesome. This is my goal, only in an S14. What are you using for Engine Management?