Yep only stalled when ac on. Was because idle was too low with compressor load. AC still worked at idle, but alternator output dropped to much to keep up with consumption from lights, etc etc.
Fixed it by finding terminal on AC amplifier that was +12v when Ac & blower were switched on, fed...
Na sorry I mean if your driving n have to stop suddenly like at a roundabout, you put the clutch in and the revs drop too low for the motor and it stalls itself.
The AC isn't going through the ECU currently, think I need to wire it through for it to compensate idle speed.
The mechanic I had gas...
Hi, thanks for the reply Samsdad. It's a uzs131 crown motor in a ln106 hilux, with the manual 5speed. Didn't know about the refrigant problems will quiery the AC man next time I see him.
It works fine cooling wise, just stalls when coming down from revs over 3000 when you put the clutch in...
Thanks for the reply, weve had nearly 50mm rain today, and been drissling for about 4 days. I must have a rust hole in bottom corner of windscreen or in air vent or something cause i found water coming down onto the ECU. mmmmm
I relocated it into the passenger kick panel,(ln106 hilux) so i...
I have a problem with my 1uz, yesterday it just started surging with a really high idle.
At first I thought it must be the IACV and pulled it down, cleaned it, adjusted it open a little and re fitted it without connecting the electrics to it. It idled low and coughed and spluttered a bit under...
Im interested in this thread, ive just hooked up my ac, it works fine at idle though. However i would like my rpm to bump up as per factory so as my alternator can still produce a decent current when idling about.
When my comes on my rpm drops a little which is mainly noticable in my...
Spot on with your last post sideshow.
Found main relay wasnt getting power from battery, cause, a blown fuse. Was a little plastic holder that melted from the current draw i think so will try n find a heavier type fuse holder for it.
Yeah i looked at 1 with an auto and decided i wanted to...
ah so your saying the power in to the circuit opening relay should come from pins 11 & 12 on the 22pin connector!
That would actually make sense! Will have to go and track down why they run into the engine bay then, as the circuit open relay is mounted beside the ecu, in cab.
Na bought it...
Ok thanks sideshow, the centre pi on my circuit open relay has two wires running into the engine bay, So you reckon they shoul come from ignition?
What would the sensore on the motor be?
Hi, any help is extremely appreciated.
I recently purchased a LN106 hilux fitted with a 1uz which i have identified as a uzs131.
Today the fuel pump just stoped, after some elimenation i found the relay which has been wired close to the ECU isn't getting power to the centre "B" pin on the...
As title, seeking 1uzfe from a crown i believe(will remove this weekend to confirm).
Working order preferred can also do exchange if preferred.
PM if you know of 1 please, Im located Tamworth NSW, AU
Cheers -beavis-