Tianheilong
New Member
- Messages
- 1
1uz-fe vvti from a '99 GS400 into an '05 is300.
everything works as it should except traction control.
there are 5 signal wires neo/eng+/eng-/trc+/trc- that connect abs modules to the ecms in both cars. The is300 abs module doesn't "see" the 1uz ecu & I assume these computers aren't programmable.
what are the possible solutions to this?
everything works as it should except traction control.
there are 5 signal wires neo/eng+/eng-/trc+/trc- that connect abs modules to the ecms in both cars. The is300 abs module doesn't "see" the 1uz ecu & I assume these computers aren't programmable.
what are the possible solutions to this?
