New profile posts

hi zuffen.

i need help with my g/box wiring. on which pin do i connect the etc-pwr switch and on what pin does the o/d button go? ecu-3a240 1uz non-vvti a341e
as best i can tell there's no OD2 pin. there's a PWR-(28pin5) PWRL+(28pin6) and OD1(28pin7).

appreciated
hugo
Zuffen
Zuffen
Sorry for the very slow reply.

I haven't worked with any Toyota auto trans so so can't help you.

Have you tried posting in the Forum proper?
1992 sc400 1 st owner put 50,000
i put 50,000 miles
changed oil every 2,000 miles
clean body no rust
just put in rotors
pads, calipers
belt, water pump
paint good, rear spoiler faided
driver seat shower wear
starts right up
bad stuffs a stumble on hare acc
changed almost every thing
under hook still stumbles
it drives me nuts i can't find it
the stumble
a
well taken care of
$5000.00
Damac Hills 2 is a luxurious and upscale community located in Dubai. It is a gated community that offers a range of amenities and services, such as a private beach, a fitness center, and a golf course. Damac Hills 2 is a great place to live if you are looking for luxury and convenience.
Pragmatic-1000x380.png

Situsslot777 merupakan agen slot777 online deposit pulsa tanpa potongan terbaik di indonesia yang menyediakan RTP LIVE slot777 gacor.
Did you sort out measuring the engine in the end? I seem to be having the same discrepancies as you!

Best wishes

Chris
Agen slot online merupakan situs judi slot online Diindonesia Yang terpercaya dengan tingkat kemenangan tertinggi.
Ditambah dengan pelayanan dan keamanan yang terpercaya bagi para petaruh di Indonesia.
Dengan menerapkan teknologi terbaru serta proses Slot Deposit Pulsa Tanpa Potongan sudah bisa dilakukan
Cukup dengan menggunakan 1 ID saja,
My car idle roung on hills whether down or up but worst in an upward position what can be the possible reason for that or can cause it
Hey Ben, I saw your scimi project on your website. You mention trunnion replaced by jag ball joint. from what I can make out it looks like you used a complete jaguar lower wishbone and vertical to achieve this? Are you able to tell me whether this was taken from an XJS model? It's hard to make out but it looks like it might be? Any issues with camber/caster compared to original wishbone setup?
Are you guy I need to talk to rebuild engine harness
G
gloverman
Sure. Have you seen my YouTube?
W
William x
Hi everybody
Just require some advice on the kind of Lexus V engine to mate on freelander1 1.8 East West engine compartment, kind of propshaft to use and mountings?
I wanted to buy 4.3l 3uz lexus v8 engine with gearbox.

Also what about fuel pump as the freelander1 has in-tank petrol pump?
Doubt you’ll respond but I’m the new owner of your car and would love to ask some questions about it!


Top