G gte New Member Messages 338 Location Maryland May 7, 2007 #1 Does anyone know the deck height of the 2uzfe (should be the same as the 1uz or 3uz) and the distance from the crank center line to the top of the block deck?
Does anyone know the deck height of the 2uzfe (should be the same as the 1uz or 3uz) and the distance from the crank center line to the top of the block deck?
Lextreme II Just call me "Lex" Messages 12,033 Location City of Halos May 7, 2007 #2 http://lextreme.com/forums/showthread.php?t=4392
G gte New Member Messages 338 Location Maryland May 7, 2007 #3 Thanks Lex, So 222.4mm or 8.756" is for the 1uz, 2uz and 3uz? And this is a measurement from the crank centerline to the top of the block, correct? What is the measurement from the bottom of the cylinder to the top of the block?
Thanks Lex, So 222.4mm or 8.756" is for the 1uz, 2uz and 3uz? And this is a measurement from the crank centerline to the top of the block, correct? What is the measurement from the bottom of the cylinder to the top of the block?
Lextreme II Just call me "Lex" Messages 12,033 Location City of Halos May 7, 2007 #4 Man, It has been a while and I dont remember.....
G gte New Member Messages 338 Location Maryland May 7, 2007 #5 Well I guess I'll have to buy a caliper and try and find out?
N nissan-lover New Member Messages 23 Location UK May 7, 2007 #6 For the deck to bottom of bore try using stroke + piston length +2mm or so, it will be close to that. Mike
For the deck to bottom of bore try using stroke + piston length +2mm or so, it will be close to that. Mike
Lextreme II Just call me "Lex" Messages 12,033 Location City of Halos May 7, 2007 #7 I think it was from the center of the crank. Here is a good link http://www.rbracing-rsr.com/squishcalc1.html
I think it was from the center of the crank. Here is a good link http://www.rbracing-rsr.com/squishcalc1.html