Hi Justen , how are things going , can you email me at [email protected] , what to chat to you about the turbo's you were running in you car . Cheers Mario
I ran a Blown SBC Methanol race engine for years and that thing had 125psi cold and around 85/90psi hot , Idle @2200rpm on 60W oil ,Never hurt a bearing in all the years I ran it , ran easy safe tune . because of the track (Townsville) still run 7.0 @ 203mph .
I know this is an old thread , But I have a 1994 UZZ32 and it has the smaller rods , I think mine was 8/94 or 11/94 and also 10.5:1 pistons . From what i know they went to the smaller rod in August of 1994 .
Set of pre 94 Balanced con rods with L-19 ARP Rod Bolts AUS$250ono
Lextreme Cams Stage II Cams .Intake only used for a few weeks and exhaust never been used , $600 ono
Used Toyota Timing Belt , did about 800K's Like new , $35 ono
1991/93 Tail Lights in very good nick , $80.00 ono
Full...
Hi Guys , I have been doing some work on my engine and sitting there looking at the Ignition (Distirbutor's ) Does anyone know of or seen someone run anything other then the two stock Distirbutors in the 1UZFE ? What I was thinking was could you run ONE MSN Distirbuter on say the right hand side...
Hi Guys ,I have a UZZ32 SUperchargde, can anyone help with a problem i have . I don't know if i caused this or not but all was fine with the car apart from pinging problems i have had after putting the M90 on it , Running Meth/Water injection to help with problem but at 7psi it pings at around...